[. . . ] 18 Open the headrest and remove filling and other items . . . . . . . . . . . . . . . . . . . . . 19 Insert the mounting frame in the headrest . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The manufacturer cannot accept responsibility for any damage caused as a result of improper fitting of this device. 16 ACCESSORIES Accessories Accessories supplied Connecting cable Extraction tool Operating instructions Mounting plate Adapter cable for a direct connection to an AV source - IR remote control IVRC-06 FITTING Monitor installation Note: It is recommended that the fitting is carried out at a specialist workshop. DEUTSCH DANSK PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Fitting Prepare the working area Remove the headrest, and place it on a working surface that has been cleared and cleaned, where the further assembly procedures may be carried out. Note: Take appropriate action to ensure that the headrest is not damaged while fitting the monitor. Available accessories - Monitor bracket 7608009300 The installation instructions are included with the bracket. Note regarding VIDEO IN/AUX: Only use original Blaupunkt accessory 7 607 001 510. Or else use a mono plug. Mark out the dimensions Feel the covering of the headrest carefully to ensure that there are no invisible parts that would prevent the monitor from being fitted. Mark out the surface that needs to be cut out - its size must match that of the installation frame. 17 FITTING Open the headrest and remove filling and other items Carefully lift the covering material away from the cut area. Adjust the cutting depth of the knife to about 2. 5 cm, and cut into the headrest following a line about 0. 5 cm inside the marked edge. Carefully lift the filling material at one corner, and cut deeper into the material with the knife. As you do this, lift one piece of the filling material, and ensure that the cut is being made to an even depth. Insert the monitor to check that it will fit into the cut area, and make adjustments if necessary. Carefully cut open the headrest cover Use a knife with an adjustable cutting depth to cut out the planned area. Make the first cut inside the marked area at a point about 0. 5 cm from one of the corners, then make a diagonal cut to a point about 0. 5 cm from the opposite corner. Make a similar cut between the other two diagonally opposed corners. 18 FITTING DEUTSCH Lay the cable through the headrest Now pass the supplied cables through the opening so that they emerge from the underneath of the headrest. Now connect the power supply, ground and video signal cables, to check that the monitor is working. Inserting the monitor Before connecting the monitor, pass the connecting cables through the holes provided in the mounting plate, as shown in the illustration. [. . . ] VOL · arrow button Decrease the volume for the selected monitor. 5 CH · arrow button / Channel selection if the monitor is connected to a signal controller IVSC-3302 or IVSC-5502. [. . . ]